Then, using the same method as with a kit, pump a cleaning solution through the beer lines and into the bucket, flushing it with water afterwards to ensure it’s clean and clear. provided along with your kegerator, you'll have to soak the faucet and couplers in a have already discussed the things we will need for making the beer lines clean and This perhaps is the million dollar question i.e. Ideally, this whole step should be followed at least thrice. Once you’ve removed the pieces, carefully dry them and scrub them with the little brush that comes in your cleaning kit. The first thing to do is clean it as you would if you have a kit; using warm water, soap, and disinfecting wipes. I will discuss these mixture of warm water and cleaning powder. As there are many different types of kegerators, it’s important to check the manual to see how to do this properly. Ensure that the keg is pressurized using a hand or foot pump, and then attach the beer tap line. Once you’ve removed and the parts of the tap, soak them in cleaning solution and warm water. Wipe All of the Open Surfaces Down. Now it's all a matter of putting them to proper use. It’s important to get all of the surfaces, as some of the least likely spots can create the most bacteria. unscented soap. The first thing you need to do is make sure your kegerator is turned off and the CO2 tanks are turned off and taken out. This is to ensure that no buildup is sitting around on the visible surfaces. If you’re missing a part, search inside the kegerator to see if it got lodged somewhere it’s not supposed to be. Kegerators are a great way to keep the party going. The CO2 too has to be turned off. The last two things can be prepared at home but you will have to be Carefully disassemble the faucets and couplers. altogether by unplugging it. If the water starts to turn a different color, replace it. From here, use the pump to pass the cleaning solution through the tube and into the bucket underneath. After you’ve cleaned the beer lines, it’s important to clean the faucets and couplers as well, seeing as they are breeding ground for bacteria. Thereafter, the regulator This is basically the cleaning of a kegerator from the outside. Once this is done, simply reassemble your kegerator and start using it again. Kegerator Cleaning Kit. One end of the beer lines Using beer line cleaning pump that is located in your cleaning kit, fill the container part with a mixture of warm water and beer line cleaning solution. Then, clean the inside surfaces, such as the beer lines, the spigot, and the tap. Make a warm-water solution to clean these parts in a large bowl and let them sit for around 30 minutes to an hour. you just have to fill the bottle up with the cleaning solution, start pumping it so that the Now we'll talk about the essentials that we of hot water and cleaning powder. the parts of your kegerator and it will be ready for use again. cleaning solution. How to clean keg lines without kit ? that end up getting replaced, reason being they wear out fast. (adsbygoogle = window.adsbygoogle || []).push({});
, Cleaning a kegerator without a proper kit isn’t difficult or impossible. Make sure to wipe down the tap, lines, spill tray, regulator, and tank. You also should wipe the inside of the cooling unit. In order to be able to access that beer lines and clean them, you’ll need to remove the faucets and coupler. This will thoroughly clean the sides of the beer line and remove any built up grime that may be contaminating the lines. This is the easiest way to make sure that you’re pouring nothing but crisp, tasty beer. Then, using the pump you use to clean the beer lines, clean the insides. how do you clean the beer lines? DIY many a time If possible, follow those instructions as they will be able to ensure that you’re not damaging you beer lines or kegerator as a whole. completely.